+- GetSimple Support Forum (http://get-simple.info/forums)
+-- Forum: GetSimple (http://get-simple.info/forums/forumdisplay.php?fid=3)
+--- Forum: General Questions and Problems (http://get-simple.info/forums/forumdisplay.php?fid=16)
+--- Thread: Matomo opt-out iFrame (/showthread.php?tid=10792)
Matomo opt-out iFrame - SoHo22 - 2019-04-25
Hi there,
I have a problem with matomo opt-out iFrame. First the URL has been altered when copies in source code of my GDPR-page. The editor transformed all "&" into "&". Then I activated the "full"-toolbar, but the iFrame code didn´t work there.
Has someone a solution for this problem? I need the iFrame in my data protection page content. Therefore a component-solution where the iFrame is shown below or aside the content wouldn´t work. Or do you have an idea how to add a component inside page content?
Thank you and best regards,
SoHo
RE: Matomo opt-out iFrame - Carlos - 2019-04-26
(2019-04-25, 20:42:51)SoHo22 Wrote: Or do you have an idea how to add a component inside page content?
You can use the Dynpages plugin.
RE: Matomo opt-out iFrame - SoHo22 - 2019-04-26
Thanx a lot, dynpages work like charm!
RE: Matomo opt-out iFrame - MichaelDi - 2019-05-11
(2019-04-26, 00:52:40)Carlos Wrote:(2019-04-25, 20:42:51)SoHo22 Wrote: Or do you have an idea how to get the most out of these tig welders and add a component inside page content?
You can use the Dynpages plugin.
Any alternatives to Dynpages, Carlos?
RE: Matomo opt-out iFrame - Carlos - 2019-05-12
Yes, there may be some. But, what's wrong with Dynpages?