Support for TinyMCE Plugin

[Alan-A]

Hello Andr0s,

I have this problem too but hadn't posted it yet because I've a workaround and because other things were more pressing (see post 26 above).

The problem here is that the TinyMCE admin interface is interacting with other plugins - in your case RandomAds.

You can get around this by simply not using the TinyMCE admin interface and directly editing the relevant TinyMCEPlugin.xml configuration file. However, you first have to get the plugin to either generate its configuration file - i.e. get its admin interface to work properly once (which will probably happen if you temporarily deactivate all your other plugins) or you get the file from elsewhere.
I could send you one later on today (I can't access my development server from where I'm sitting at the moment) but you could also generate your own:

• Simply do a quick install of a clean GetSimple without any plugins (only takes a few minutes).
  
• Then install TinyMCE
  
• Run the TinyMCE admin for the plugins (i.e. buttons) that you want
  
• Copy the .xml file TinyMCE generates out of the GetSimple "data" folder (or one of its sub-folders, I forget which) into your 'main' GetSimple installation
  
• Note that the TinyMCE admin interface does not read this configuration file, so if you inadvertantly run the interface it will overwrite your .xml configuration file. So make a backup :-)
  
• Note also that I have only managed to add extra buttons into the fourth row of the editor - I think you will need to hack the TinyMCEditor.php file to get it to allow you to add to the other rows
  

Finally, if all else fails, did you know that you can activate a wide range of features for the default GetSimple editor? There are instructions about how to do this in this site's wiki.

Good luck,

A.