2010-07-12, 03:29:53
Hi there,
I really appreciate the simple
I really appreciate the simple
Inserting images to a page
|
2010-07-12, 03:29:53
Hi there,
I really appreciate the simple
2010-07-12, 03:31:06
Full post:
----------- Hi there, I really appreciate GetSimple cms but i don't understand why i have to put the full url of my images in order to use them in a page. If i put an image with the full url (http:// ...) the image get displayed in the editor but if i try the relative url /data/uploads/myimage.png) i get an "x" in the editor. Is it wrong the relative url i'm using ? Thanks
2010-07-16, 22:16:50
Hi,
Isn't my question clear ? I would like to insert images without using the full url ("http:// ... "). What is the relative url i have to use ? Thanks gioacchinomauri Wrote:Full post:
2010-07-16, 22:31:36
/data/uploads/myimage.png should be the right relative URL. Unless you have GetSimple installed in a subdirectory.
If GetSimple is installed on http://example.ms/getsimple/ instead of directly on http://example.ms/ you’re going to have to use /getsimple/data/uploads/myimage.png to point to your image. I hope this helps you out, I don’t really have a better answer ready for you I’m afraid.
“Don’t forget the important ˚ (not °) on the a,†says the Unicode lover.
Help us test a key change for the core! ¶ Problems with GetSimple? Be sure to enable debug mode!
2010-08-10, 22:38:01
Ive hade the same in edit mode you see the image if you use ../image or ../data... but dont in the real mode from outside but if you use ./ in edit mode uou dont see the image in edit mode but in the real outside
2010-08-15, 00:29:40
Why would you use ./ instead of just /? Using just a / refers to the root of the domain, so if GetSimple is installed there /data/uploads/ will always refer to the uploads folder and is a fool-proof way of linking to anything.
I haven't tested it in CKEditor, but if you link it there starting with just the forward slash it should even display the image there.
“Don’t forget the important ˚ (not °) on the a,†says the Unicode lover.
Help us test a key change for the core! ¶ Problems with GetSimple? Be sure to enable debug mode! |
« Next Oldest | Next Newest »
|